brisnat81
Well-known member
Hi MrX
The Plastic Under the control board is on a 45 degree angle. The tub would have to hit the galvanised Bracket and the lid of the machine before it could go high enough to hit the shroud and control board.
It's quite a good design, as that area of the machine would require a huge component failure for moisture to get up there.
On the earlier machines the computer was located on the inside of front panel that swings open. Right next to the boot on the right hand side. A perfect location for water damage should the boot spring a leak.
Its a bit dissapointing that the drain flap appears so close to the floor. You get about 4" clearance on the 5 and 6kg machines. It seems silly to have dropped it down that low unless it is an optical illusion.
Otherwise it still seems to have the Miele quality inside and out.
The Plastic Under the control board is on a 45 degree angle. The tub would have to hit the galvanised Bracket and the lid of the machine before it could go high enough to hit the shroud and control board.
It's quite a good design, as that area of the machine would require a huge component failure for moisture to get up there.
On the earlier machines the computer was located on the inside of front panel that swings open. Right next to the boot on the right hand side. A perfect location for water damage should the boot spring a leak.
Its a bit dissapointing that the drain flap appears so close to the floor. You get about 4" clearance on the 5 and 6kg machines. It seems silly to have dropped it down that low unless it is an optical illusion.
Otherwise it still seems to have the Miele quality inside and out.