Need some help with me washer
- Thread starter Compwhiz
- Start date
Help Support :
To remove the cabinet to replace the pump I guess is what you aree asking. Right?
Remove the two screws from the bottom of the control panel. Pull panel forward and up. Then lift it up and back so it is out of the way. Remove the two large clips using a screwdriver. disconnect the lid switch connector. It is the one attached to the cabinet near the center. Tilt the cabinet top forward and pull it straight off. You will then have access to the pump. Remove the clips holding the pump to the motor. Remove the two hoses to the pump. Slide pump off motor shaft. Hope it isn't rusted on. Good luck.
Remove the two screws from the bottom of the control panel. Pull panel forward and up. Then lift it up and back so it is out of the way. Remove the two large clips using a screwdriver. disconnect the lid switch connector. It is the one attached to the cabinet near the center. Tilt the cabinet top forward and pull it straight off. You will then have access to the pump. Remove the clips holding the pump to the motor. Remove the two hoses to the pump. Slide pump off motor shaft. Hope it isn't rusted on. Good luck.
Thread 209 was created in the Imperial Forum.
That's strange, I see thread 209 right smack in the middle of the Imperial Forum listing, with lots of other threads below it and its still clickable. Greg, try hitting reload when you viewing the Imperial Forum listing.
Thread# 209 Vibration and noise
Originally Posted: 10/4/2004-16:31 by hairybigmanuk
Number of Replies: 5 -- Last Reply by goatfarmer, at 10/6/2004-04:32
Robert
This is the thread in the Imperial section but it is all red and no underlined link to click. It is at the bottom of the page after the underlined clickable threads.Reload does nothing. Still not clickable on my computer. Also looked in the archive thinking it may have been archived but it is not there either.
Originally Posted: 10/4/2004-16:31 by hairybigmanuk
Number of Replies: 5 -- Last Reply by goatfarmer, at 10/6/2004-04:32
Robert
This is the thread in the Imperial section but it is all red and no underlined link to click. It is at the bottom of the page after the underlined clickable threads.Reload does nothing. Still not clickable on my computer. Also looked in the archive thinking it may have been archived but it is not there either.
I see what you mean now Greg, Netscape or as its more commonly known Netscrape is not reading the page properly. I will have to experiment and see if I can get it fixed. In the meantime I would use IE to view the pages.
bpetersxx
Well-known member
Robert all 3 discussion groups are that way.
It starts half way down.
Mozilla Firefox is doing it too so I assume plain mozilla is also.
pete peterson
It starts half way down.
Mozilla Firefox is doing it too so I assume plain mozilla is also.
pete peterson
bpetersxx
Well-known member
etc
Robert it works with Netscape 4.7 so it is something with the newer Netscapes.
pete
Robert it works with Netscape 4.7 so it is something with the newer Netscapes.
pete
I use Mozilla Firefox and wasn't having any of the described trouble . . . UNTIL I used Firefox's "find text" function on the index page for the Imperial section. Now everything on the Imperial index page is all red and unclickable from thread # 228 and down (well, that is, at the position of thread # 228 at the moment I'm typing this post).
