still asking that agitating question?

[kenmoreforever]

How do you put a Kenmore agitator back togethyer as in top and bottom parts after they have been sperated from each other? I know how to replace the dogs just fine.

 

[toploader1984]

once you put the top part on or "corkscrew" there is a center piece that the dogs are attached to, just insert it in the center, there should be a grove to line it up, make sure the dogs are facing up, it can get kind of tricky b cuz the dogs can fall out while ur trying to get it in place. it should just snap in place, you will see a little tab at the bottom that it snaps into. once it is installed in the machine the bolt at the top should pretty much hold everything together.

 

[toploader1984]

agitator repair

repair

 

[toploader1984]

some agitators do not have a rubber seal at the bottom, mine had a plastic washer that went between the corckscrew and the base of the agitator.

 

[kenmoreforever]

Well I know I'm not losing my mind because this is how I've always done it as shown above. Maybe it's the new one that has me stumpted. I am currently messing around with a new model Kenmore and the agitater come apart on me and I cant get it back together to save my life. I will most likely go back in with one from an older machine as I have plenty of these. Maybe it is the new one thats different?

 

[yogitunes]

would this be an agitator thats called a TRIPLE?...usually found in kenmores only...it has a spring inside that allows the auger to "bounce" up and down as it washes...that i believe is only one that is different from all the rest....other than that they all go together the same way....with your eyes closed!...