the Haier problems

[bpetersxx]

well

Haier XQG50-31

the dispenser flushes the bleach side in the 2nd 3rd and 4th rinse portions of the cycle

guess that is normal

the water fill valves are slow to fill until hot water is run thru them

also they sometimes do not close even with no power to the washer

and the dryer part blows the safety fuse
but do not use that as it uses loads of water

Haier XQG50-qf802

the fill to dispenser hoses cannot be tied up as it causes the fabric softener to dispense too soon

comment if you want me to post the rest of the video links here

 

[DADoES]

 
Both valves are ornery about shutting off?  Do you have low water pressure?  Water pressure is what makes the valves close when power is removed.  20 psi is typically the minimum for proper function, and of course low pressure will make for long fill times.

 

[gizmo]

water valves slow till hot water goes through

This is typical of valves where the rubber diaphragm is getting old and less flexible. The hot water softens them temporarily.

Time for new water valves.

 

[bpetersxx]

pressure is fine at the faucet

oh boy well time to hunt for new valves

 

[bpetersxx]

oopps

get ready for the fuzzy logic haier thread coming real soon

 

[bpetersxx]

y

 

[bpetersxx]

update

took the hoses off to check it out

pics coming as it is different conf

 

[bpetersxx]

ok I'm the dunce here

I did not follow the advice of check the filter screens to see if they were dirty

The hot side was dirty but not too bad

BUT

The cold side was filthy

And clogged completely up

Ok say it

 

[gelaundry4ever]

honest

At least you're honest.