What does this transmission go to?

[volvoguy87]

I will post a picture as soon as I figure out how to get it from my iphone to AW.org.

The crate says Bendix and Crosley. The man who has it has several more and they are available. He owns an appliance resale store and has had these in the basement for several decades and would like to get rid of them. They are NOS, not used or rebuilt. He's not asking for all the money in the world, he'd just like to be rid of them and have them go to a person or people who would find a better use for them then scrap.

Dave

 

[volvoguy87]

A picture

Here it is in all its glory.

Dave

 

[recyclewasher]

how much he asking for one?

And are there any stamped numbers on the tranny?

I have an old bendix motor being shipped to me and if I find the pic of it

I'll post it up so you can show him to see if it will mount to it?

I'm interested

 

[volvoguy87]

Bump

Bump

 

[recyclewasher]

only pic I can post until the .

repair guys clean my laptop of a virus i picked up while surfing.

 

[recyclewasher]

does your source have any spare or used..

Motor shaft pulley for the motor pic I posted?

And I'm also looking for a water pump for the same motor too!

 

[volvoguy87]

Guesses?

I'm thinking maybe a Bendix Economat or a Powersurge.

Any thoughts?
Dave

 

[Unimatic1140]

That is odd, it certainly isn't a power surge becuase there was no transmission in that. I've had the Economat transmission out and it looks nothing like that, unless this is a really early Economat tranmssion?

 

[combo52]

Mystery Transmission

Even I have never seen this transmission, so if I had to guess I think it goes to a wringer washer, if we could get a closer look at the agitator shaft it would be easy to see if it went to an automatic washer or a wringer, but from what I think I am seeing I am going with wringer washer.

 

[Unimatic1140]

I didn't even think of that but I bet John is right, it must be for a wringer washer.

 

[recyclewasher]

I'm not familiar with wringers at all

Closest I've been to are pics on AW.

So I took the liberty of asking questions on the actual pic posted in the thread if that's ok?
Cause I'm seeing two possible senarios that I could use it in so far (far better than landfill) as that agitator outer post looks unbelievably THICK!

1. Extremely powerfull KM BD style drive agitator washer (intense fabrication of suitable basket to fit and agitator adapter plus outer tub..

2. As above but to use as a plant mulch mixer with fabricated auger instead of agitator

 

[recyclewasher]

some bendix dryer small mod pics

Yesterday's proj,

 

[badgerdx]

font geeky goodness

I don't care what it is... but DAMN I LOVE THAT FONT...

 

[recyclewasher]

I found on trial run of dryer, way

Too much heat on cabinet top and side panels

 

[recyclewasher]

also was seeing a little lint bypassing

Through Small gaps on and near lint trap,

Still have to install brackets, closing felt strips etc,

Tee nuts? Socket plugs? Something quick for an easy plug n play

 

[recyclewasher]

LOL, yep I admit it ..

Paint brush font selection menu threw me for a loop,

So did a not so quick improv!

 

[recyclewasher]

ooops not in sequence, but

You get the general idea..

Paper pattern (bristol board) first, make corrections then transfer to aluminum sheet after.

Then complete the rest of dryer mods, and then

Start on creating matching washer using "wringer parts tranny" to bd agitator washer!