Whirlpool Calypso -- does this look right to you?

[Marky_Mark]

Hi Guys

I've been eager to get my hands on a Calypso for a while now, and I'm excited to see one has just come up for sale. Before I commit to a 7-hour round trip, I was hoping some of our resident Calypso experts, such as @DADoES and @combo52, could share their thoughts on this one.

It might just be a camera angle, but I'm a bit concerned about the wash plate seal. It looks like it might be making uneven contact with the inner wash basket, perhaps too close on the right-hand side, and possibly a significant gap (or is it just a shadow?) on the left.

Does this look normal to you, or should I be cautious?

Thanks in advance!

 

[DADoES]

It's tricky to determine from the photo. Could be a shadow being that the lighting is primary at the opposite side. A slight gap is normal, else there'd be abrasion that'd wear it down and create a gap.

Signed: Goofy Glenn

 

[Chetlaham]

It almost looks like the disk is not centered post nutation- like it just shut off midway during nutation. Could be bad could be a coincidence.

 

[Marky_Mark]

Thanks for your input, guys — I really appreciate it.

This Calypso is the only one I've seen for sale so far, so in the absence of other options, I guess I'll go for it and just hope for the best! I’m not sure which "KQ" version this is.

Mark

 

[combo52]

Hi Mark, it looks fine to me, there is always a slight gap, is this a whirlpool or a Kenmore model?

Hopefully it’s in good shape. We have lots of parts for these if it has any difficulties.

The calypso is one machine I am endeavoring to never be without. It’s a really fun machine for really dirty stuff that needs a thorough cleaning.

Do install a bypass lid switch so that you get to watch the fun.

John L

 

[Marky_Mark]

Thank you very much, John. This one is a Whirlpool version. I've read many of your posts regarding how you use your Calypso for really dirty white loads and how it cleans great and does a good job of rinsing away the detergent and bleach. And you've mentioned that it always completes the cycle on time and never fails to balance for spin. It sounds great! Your posts are what inspired me to look for one. Thank you for the heads up regarding your parts availability. I'll be back in the US on Friday and will hopefully be able to collect it this weekend. I'll keep you guys updated.

Mark
P.S. I'll definitely install a bypass reset switch for the lid.

 

[neptunebob]

I thought the Calypso was a "dud" and that is why it was discontinued.

 

[qsd-dan]

I thought the Calypso was a "dud" and that is why it was discontinued.

They were, having serious issues with control boards, pumps, motors, U-joints, and seals.

 

[Marky_Mark]

From what I can gather, the Calypso apparently performed very well but was unreliable and far too expensive to manufacture. So the plug was eventually pulled, despite many of the earlier problems being ironed out on later versions.