Whirlpool Refrigerator Repair

[whirlcool]

OK, I got the parts in for my Whirlpool refrigerator. I got the new water solenoid in and it works fine. Now I need to install the replacement ice door in the freezer door.

But I can't seem to figure out how to get the trim off the front of the door so I can access the ice door area. How do you remove this? I don't see any screws or clips anywhere. This is the piece on the front with the Whirlpool Logo on it and the buttons for Crushed/Cubes and Water and night light switch. There were no instructions in the kit about how to do this.

Advice anyone? Thanks!

 

[DADoES]

It may simply snap off, as does the dispenser trim on my GE Profile.

But tug on it carefully!

 

[whirlcool]

By the way...

I forgot to thank whoever it was that told me where to find the water solenoid.(DADoes)? I certainly appreciate it! Easy repair.
And I am so glad that it's working again as we use a filter on the water supply to the refrigerator to remove chlorine and cysts from the water for one of our elderly dogs. She has some mild kidney problems and the vet said bottled water would be best, filtered water should be just as good.
Also coffee made with Chlorine free water tastes much better.
I am so happy to be a member of this site, not only do you save money repairing your appliances yourself, but you get a nice feeling of satisfaction when it all comes out ok!

 

[coldspot66]

It was me.............it was me.........(waves hands in air).
Glad everything worked out well............believe it or not, Whirlpool has a pretty good repair record on side by side refrigerators!!

 

[whirlcool]

Thanks a lot John, I appreciate the assistance.
Now all I have to do is sand down the rust spots on the door and touch them up with the touch up paint. I used a little bit of bondo to fill in the rusted thru spots in the door.

I still can't believe all this for a refrigerator that is only about 6 years old!