I'm with John on this....
...you also might want to check that the water line isn't crimped when the fridge is pushed back into place restricting the water flow. Mark
my 2 cents...
If the machine is level, and the tub is still off by half inch, you might want to check the damper pads and replace them.
Lint removal is best on full loads. At small, there is no water that circulates through the agitator filter.
Without hearing the thud it's hard to even make...
Congratulations!
Greg, I had a machine just like this in my first apartment! I absolutely LOVED it. When I bought my first house, the old GE went to the curb, and a new THERMADOR steam machine was installed. While those dishwashers didn't have a filter in them, they still did a great job. I...
The best way to see if the balance ring is...
defective, is to remove it and let it spin. That ring is only useful when there is a load of clothes in the tub. An empty tub with no ring should spin perfectly....we're not talking Whirlpool here..... jus sayin...
The washer is 3 and a half years old. AWN series... When the machine starts to spin it almost immediately goes out of balance violently. I removed the tub balance ring and ran it empty, and it does the same thing. Thinking it had to be the springs, I replaced them all. Same problem. No...
I worked on my second Speed Queen yesterday. The machine was about 9 and a half years old. The motor was overheating and the thermal was kicking out. Since I was replacing the motor anyway, I went ahead and replaced the belt and pump (which comes as a fix kit) too. Took not quite an hour and...
I haven't seen...
... a lot of dependability from the KitchenAid dishwashers. Lowe's sells bunches of them as it's their quietest dishwasher, and I work on them almost every day. No specific bad parts other than controls....lot's of controls!