Search results

fussy FL's The best way to stop the fussyness of spinning is not to use FL's for too small a load, The 5kg ones just spin but above 7kg its fuss fuss fuss. This is exspesialy true of the 1600rpm machines as an unbalanced lode would shake the machine to bits very quikly. A good tip I discoverd...

Also It's 240v a cotton 95c wash fully loded takes about 2 hours but the average full 40c wash is about 1hour 35 mins, inluding 3 rinses and spin each time. I suppose its the time heating the water as its cold fill only. Its rare to get hot fill machines here.

11KG LG I have one of theas machines, its totaly silent it spins upto 1400rpm and if you listen you can just hear it. If I was picking flys its too fussy with smaller lodes it will mess about balancing it for ages before it makes its mide up about spinning. its amazing how much you can get in...

Hotpoint On my hotpoints you have a selection button whitch you press if you want to add softener. It basicaly pauses the machine and waits for you to add softener, you then press the button and away it goes to the end of the cycle. In the frunt loader you have a seperate slot in the soap...

Thank you When you look at it now its quite simple.

Oh ! So it dose not just get dumped out. Clever thank you.

Top loders are not common here in the uk, so I have to make do with 2 very old hotpoints, or watch them on you tube. The question is I notice that the softenher is added to the top of the agitator in a littel cup in a lot of the machines and this seems to get spun out with the wash water. Is...

Get an electrician This is a 3 phase machine, Both the heater and the pump motor are eaither 240 or 415 volt and not 110 volts. Please get an electrician to look at it as connecting it directly to your 110 system may damage the machine and or your house wireing...

Hotpoint motor My hotpoint started to spin very slowly and would need a push to get it to go. That turned out to be a Bad capacitor. Much cheeper than a new motor, :)

Kill the over sud ! I live in Birmingham UK. The water is insanly soft and too many sudds are often a problem. However a very quik instant fix is a splash of softener in the wash cycle if the sudds get a bit too much and zap they are gone. try it :)

Fussy LG I have an 11KG front loading LG. It simply won't spin unless it's full. ( 2 years old) My two 25 year old hoptpoint top loders never seem to minde what I do to them whether they are stuffed stupid or just have a small lode they just do !

Ouch POP The rubber hammer hammerd ! Two of us stood on the metal frame with one foot on the concrete weight. I twisted and pulled. I landed on my arse. But it was off. It was rusted the rubber was dust.and that spring clip around the shaft holding the rubber caused moor damage to me getting...

Hello all, I'm quite the newby and I'm here alredy on the grovel. the Machine in question has a damed fine leak from the central agitator I have got all the new parts and seals, I have undun every nut bolt and screw ( my nuckels will probably never recover) and still I cannot get the drum out...