1968 Whirlpool imperial outer tub leaking

[68imperial]

I just aquired a copper color 1968 whirlpool imperial washer and dryer set. The washer needs a new outter tub seal and the 4 tub bolts. Their is a slight rusted section on the bottom of the outter tub. i was wondering if a water proof glue would fix this little problem or will i have to search for a replacement tub. Tom

 

[goatfarmer]

You can try POR15,but depending on just how rusty it is,the POR might just be a bandage.

kennyGF

 

[fixerman]

If the rust hole is near a bolt hole, There is a replacement bolt kit with extra large rubber washers. "SealAll" sealant works well for small holes. Could also use plumbers epoxy.

 

[68imperial]

Hi everybody Thank you for the advice. I will try that and see how it works. I will try to load pictures if i can figure out how to get them to load up. thanks Tom

 

[kenmore1978]

So

What's the latest news?

 

[68imperial]

Whirlpool success

Hi Everyone I was able to fix the leak and all is well. The machine is back in service. This is an excellent site and i want to say thank you to everyone that was able to help me out. Tom

 

[SactoTeddyBear]

Re: Inquiring or Wondering Minds:

Hi! 68IMPERIAL, would like to know which suggested way of trying to do your Repair was your decision, that worked for you?

Your WP Washer should give you a lot of years of Happy "Sudz-Cake" Washing, besides the Fun of watching it operate.
Congratulations on your successful attempt to save another Vintage Washer and giving it more life again.

Peace and Holiday Cheer, Steve
SactoTeddyBear...

 

[68imperial]

Repair method

HI The repair method I used was to replace the tub bolts, used an epoxy sealant to seal the small rust hole in the outer tub,and also I replaced the center tub gasket just to be on the safe side. This is a really impressive washer. Thank you for the inquiry.