"Before" pics were requested, so here be a bunch of 'em.
Catalyst-Match Dryer Refurb In Progress
- Thread starter DADoES
- Start date
Help Support :
"Before" pics were requested, so here be a bunch of 'em.
$0.02 stuck behind the door. And found $0.23 behind the moisture sensor housing on the bulkhead.
Typical blue staining from denim dyes.
Has the skid-type belt idler ... which of course will be replaced with the replacement pulley-type.
Note the sound insulation pad to the right.
Found this extra top-locator pin down here, apparently left from the factory.
Insulation pad on the left. They're listed at $99 (I assume for the pair) on SearsParts! $85 at PartsTap.
Lint-infested motor.
Blower housing with thermal fuse (white, upper) and thermistor (black, lower).
Element connection and high-limit 'stat.
Bottom of filter housing. The fuse was initially stuck in the lint higher up at the drum air intake, it fell down when I bumped the housing.
Up here is where the fuse was stuck.
Back of the air intake on the bulkhead. The foam seal is deteriorated.[this post was last edited: 9/11/2011-21:50]
