Converting something from steam heated to electric

Automatic Washer - The world's coolest Washing Machines, Dryers and Dishwashers

Help Support :

adam-aussie-vac

Well-known member
Platinum Member
Joined
Dec 14, 2017
Messages
1,054
Location
Canberra ACT
Hey guys, so my industrial machine is going to be coming in about a month and I want to convert it from it being steam heated to electrically heated as I’ve got no facilities to heat it using steam, what’s generally a good Watage for heating a large amount of water somewhat slowly? (I have up to 15 A at 240 V available.) I even thought about using a small Pump sucking water from where the old steam port used to be humping it through a filter through the Pump up into a cheap little hot water system, one of the miniature instantaneous ones, but I’m probably instead gonna see if it is possible to fit a 240 V waterproof heating element in
 

Attachments

  • IMG_9105.png
    IMG_9105.png
    2.9 MB
  • IMG_9107.png
    IMG_9107.png
    2.8 MB
  • IMG_9106.jpeg
    IMG_9106.jpeg
    410.2 KB
Last edited:
You're likely going to require two or maybe three 2500 watt heating elements.

https://www.ebay.com/itm/223969713822

https://www.huoltopalvelu.com/Elect...shing-machine-heater-2500W?PageSpeed=noscript




Much is going to depend upon programming available for wash cycles.

That is if max wash cycle is say 12 minutes you're going to need lots of power to heat water quickly.

Then there is will you be doing starting from cold (expensive and time consuming) or beginning with hot water and boosting it up to 140F or above.

Most commercial laundries don't bother with starting from cold, but have hot water from tap and use heaters to boost temps to desired range.

Where available commercial/industrial laundries will go with steam because it's usually faster and cheaper. Of course such laundries are also using steam for ironers, dryers, ironing, steam tunnel finishers, so they have other reasons to have onsite boilers.

Contrary to what many would believe commercial/industrial washers actually inject steam into wash water for heating. In past this was done manually by opening and closing steam valves. Modern machines however have built in controls to operate said steam valves.

One consequence of injecting steam is water levels are slightly below what ought otherwise to be, this is to take into account steam injected into washer will condense back into water, which in turn will raise level.
 
As an eBay Associate we earn from qualifying purchases.
Oh, this machine does not have any set program, it’s literally just on and off and it only Tumble, fill and drain are completely manual as well as timing so I’m assuming shouldn’t it be better to let it sit and heat or tumble and heat? I’m almost thinking about having The set up start tumbling after it’s done heating to make it slightly more automatic. That means all I need to do is fill it up after closing and locking the door, and adding detergent.
 

Latest posts

Back
Top