Hi everyone, I have a 1-18 machine that has a badly chipped pulsator cone. The model is WC-7 (pics below).
I have a replacement cone assembly, but I cannot get the agitator mounting nut off. It is frozen on. Is there some special way to do this? I found a post where the individual used a vice-grip at the lowest point of the agitator shaft to hold it in place while he turned the nut from the top. Is that a safe way to do it (w/out damaging the shaft)? Any other recommendations?
If I end up having to cut it off are these mounting nuts easy to find? I searched eBay with no luck. Does anyone here have an extra mounting nut they would sell me?
Thanks in advance for any advice.







I have a replacement cone assembly, but I cannot get the agitator mounting nut off. It is frozen on. Is there some special way to do this? I found a post where the individual used a vice-grip at the lowest point of the agitator shaft to hold it in place while he turned the nut from the top. Is that a safe way to do it (w/out damaging the shaft)? Any other recommendations?
If I end up having to cut it off are these mounting nuts easy to find? I searched eBay with no luck. Does anyone here have an extra mounting nut they would sell me?
Thanks in advance for any advice.






