I am at my wit's end. I have a Hotpoint (which in my mind seems to be a cheaper GE - repairs are pretty identical) model #HTWP1400FWW. For about a week, it's skipped over the post-wash spin cycle. I have reset the logic board, blown out/cleaned the water fill sensor tube, removed and cleaned the water pump, and fooled a little with the disassembled timer switch/front spin knob. Here are the symptoms: Usually, it's drain, drain, drain, then start in on this God awful rhythmic sucking pump sound which is really loud, then just fill for rinse. It does spin on final cycle. I have got it to actually spin once after wash but it must have been luck, because it was after all I did above - yesterday - and today it skipped again. Anyone have any ideas?? I am at wit's end.