Speed queen front load - dispenser issue

[stopmeister72]

Noticed that the detergent is not getting fully flushed out of the wash compartment, prewash is fine.
Any ideas on how to fix?

AFNE9BSP113TN01

warm - wash cycle

rinse cycle

hot - wash

thanks,
John

 

[combo52]

Hi, you don’t mention how old your washer is but the most likely thing that’ll cause this is a bad inlet valve, we were refurbishing a Speed Queen stack on Saturday that was from 2015 and it had this issue and we replaced the inlet valve to solve it.

 

[stopmeister72]

not sure how old it is, maybe 7?? Got to figure out where I put the paperwork.
Went ahead and ordered a new inlet valve. Also, sometimes when it filling in the prewash section at the begging of a cycle, you can hear a rapid pulsing, so that will probably take care of it.
Have a Huebsch stacked front load at school and it has had to have the valve replaced a few years ago due to a slow drip. Over breaks would come in to a full tub of water sometimes.
Thanks,
John