Tonight I changed the spin bearing located in the upper mechanism housing, check the oil and gave the mechansim both a bench and in machine test. Everything so far, so good...
A Cavalcade of WO-65-2 Unimatics - Part III
- Thread starter Unimatic1140
- Start date
Help Support :
Bench testing...
YAY for Oil Pressure!
Be sure to check the Snubber!
Otherwise you might have extra vibration!
Otherwise you might have extra vibration!
Inside the cabinet...
The Spin Test
Hold onto to your hat...
Hold onto to your hat...
westytoploader
Well-known member
- Joined
- Sep 4, 2004
- Messages
- 4,485
YAY, very nice! My GE spins in the 600's (not sure what the actual speed is) and makes quite a gust when I ran it with the top off...so I can imagine 1140!
What happened to the missing pulsator shaft...I notice 2 on each mechanism? Was it just removed from the mechanism?
What happened to the missing pulsator shaft...I notice 2 on each mechanism? Was it just removed from the mechanism?
Hi Austin, the mechanism on the right has been there for over a year, its not the same mechanism that had the pulsator shaft broken off. That one is sitting on the floor over a coffee can at the moment dripping out every last bit of oil. Next week after I have this machine up and running I will break the bad tranny and see what's going on in there.
kenmore1978
Well-known member
- Joined
- Sep 8, 2004
- Messages
- 2,119
pulsator shaft
I can't wait to see the outcome of this one!
I can't wait to see the outcome of this one!
Similar threads
