olderisbetter
New member
Hi-
I inherited my mom's KDI-17A and have done a couple repairs on it. Last weekend, I installed a timer. While connecting wires between the timer and the program switch, I managed to knock off a very brittle hard fiber tab that interacts with the door latch. Now, when I close the door, the machine starts whether the handle is locked down or open. I have tried to find a replacement program switch but have had no luck and was wondering if anyone has a suggestion for bypassing this problem.
Also, when reconnecting wires, I noticed that the end of the orange wire connecting to the power switch was looking pretty fried. Can I get a replacement wire with end forks and where would I find it? In one of the wiring diagrams for this machine, I noticed that an orange wire connects to the heating unit. Last night when I ran the machine, the water did not seem hot so I'm hoping I can replace this wire and solve that problem.
I inherited my mom's KDI-17A and have done a couple repairs on it. Last weekend, I installed a timer. While connecting wires between the timer and the program switch, I managed to knock off a very brittle hard fiber tab that interacts with the door latch. Now, when I close the door, the machine starts whether the handle is locked down or open. I have tried to find a replacement program switch but have had no luck and was wondering if anyone has a suggestion for bypassing this problem.
Also, when reconnecting wires, I noticed that the end of the orange wire connecting to the power switch was looking pretty fried. Can I get a replacement wire with end forks and where would I find it? In one of the wiring diagrams for this machine, I noticed that an orange wire connects to the heating unit. Last night when I ran the machine, the water did not seem hot so I'm hoping I can replace this wire and solve that problem.