HI everyone, I have a Speed Queen wringer washer. I took off the bottom of the drain section under the washer to see if I had a problem with the pump. I didn't to that correctly so the rubber gasket that went between the bottom part of the drain and the top part of the drain housing is gone. What can I do to rectify this mistake?
I can't use the machine because it leaks now. This was an error on my part so could I use JB weld to fill in the gap where the rubber gasket went? There is a hand screw at the bottom of this with a clamp that would tighten it? Thanks,
I would like to wash in this but can't because of my error.
I can't use the machine because it leaks now. This was an error on my part so could I use JB weld to fill in the gap where the rubber gasket went? There is a hand screw at the bottom of this with a clamp that would tighten it? Thanks,
I would like to wash in this but can't because of my error.