See pic. Just found this rinse aid plug on a friend's dw. Is the water too hot or is the solenoid going bad? Any advice appreciated!
WP/KM DW melted rinse aid plug
- Thread starter peterh770
- Start date
Help Support :
vacerator
Well-known member
Neither,
it looks to have not been locked in the closed position, fell off and onto the heating element, or under it, and got melted during drying.
it looks to have not been locked in the closed position, fell off and onto the heating element, or under it, and got melted during drying.
Melted Rinse Aid Plug
You are exactly correct Mike, we see this all the time.
You are exactly correct Mike, we see this all the time.
mark_wpduet
Well-known member
I was thinking the same thing -
I mean, would it even be possible to melt like that otherwise?
I mean, would it even be possible to melt like that otherwise?
vacerator
Well-known member
No mark
The solenoid is behind the inner door panel and dispenser fill cap of course, right?
The solenoid is behind the inner door panel and dispenser fill cap of course, right?
Grrrrrrr...
