here we go again again 2

[bpetersxx]

update 7 tr

dead in the water again

need advice on testing the power cord

and the power filter in the console

 

[bpetersxx]

update 121rtytr

the cord is fine voltage in the cord

 

[bpetersxx]

update 121rtytr

the cord is fine voltage in the cord

 

[bpetersxx]

more update

the power conditioner I think whatever it is called has voltage

can the boards be bad

the control board has a bad socket can that cause no voltage to the boards

 

[bpetersxx]

update 7 trjgf

the machine controller board is bad

In the troubleshooting book

Page 56

Motor and Motor Control System Test

Machine control relay

4.Set the probes of a volt-ohmmeter between P16-5 (BK/WH) and P16-1 (WH/BU) on the ma-
chine controller. Start the washer by pressing HEAVY DUTY and then START. Confirm that
120VAC is present when the relay clicks closed. Press STOP/CANCEL twice to stop the
cycle.

test 4 fails

press Heavy duty but no start no relay click no beeps when button is pressed

 

[DADoES]

 
It happens.  Wait for a used one to come up on eBay, or search for a board repair service if there are any that handle it.

 

[bpetersxx]

it got complicated

I'm going to have to go thru the parts I have to see if they work

the machine controller I was putting on has a bad connector on it as well

I ended up replacing the inside assembly

have to break it in as it is flashing PF and some of the lights lit

cannot reset it yet

 

[bpetersxx]

update 7 trjgfz stgst

saga is over

Got it up and running again

replaced the entire console assembly

now to try to make better videos

 

[bpetersxx]

update 7 trjgfyutfu.ft

especially since the cycles seem to be different I think

may be wrong on that

 

[luxflairguy]

Haven't a clue what 7 trigfyul.ft means!

 

[bpetersxx]

reply #28

just some fluff i put in the headers

But the good news is it works again reliably to an extent